Dresser Drawer Pulls Ideas

Home » Interiors Furniture » Dresser Drawer Pulls Ideas

Dresser drawer pulls – with basic carpentry skills and the right tools, you will be able to build or replace your own boxes. These steps will be helpful if you are remodeling your house, fix a broken box or build your own cabinet. You can make your own custom kitchen cabinets at a fraction of the cost of buying them, with the addition of a personal, creative accent piece for the bedroom.

Posted on October 18, 2017 Interiors Furniture

Measure the width and depth of the box. When measurements, consider drawer slides. There is a wide range of drawer slides in the market, so you may want to purchase and install the glasses in your cupboard before you build the dresser drawer pulls. Cut the sides, front and back of the boxes from the timber. Use the measurements from step one to measure out and cut your two sides, front and back of the box. First, cut the timber to the desired height of your dresser drawer pulls. Next, cut the length to ensure that all four sides will be uniform in height.

20 Photos Gallery of: Dresser Drawer Pulls Ideas

RELATED TOPIC :  Ideas for Clean Upholstered Bar Stools

Seam joints to make a robust fit to box corners. Next, check your router and set the depth of about three quarters of the width of your wood. Then run the router along the left side and the right side of both face piece and your back cover. Fit the pieces together. For the bottom of the box, you have a choice of either routing out a line thickness of the bottom so it slides into the mount, or you can install it directly to the bottom. Then nail or screw your dresser drawer pulls sides together. Put wood glue on all joints and use clamps to hold them in place so they are solid.

RELATED TOPIC :  Contemporary Convertible Sofa Bed Style

Install the bottom of the slots routed around the box. After you have cut the height of the box, measure up from the ground about one-half to three-quarters inch and draw a line along the whole board. Then the way out a slit half the depth of the wood and the thickness of the bottom; do this before you cut the sides to the desired length. If you install directly to the bottom, turn the box over so you are looking at the bottom of it. Using the router, adjust it so that you will be routing out half the thickness of the wood around the inside of the box. Finally, glue and nail the bottom of the tray.

RELATED TOPIC :  Sofa Table with Storage Design